Adsorption Elemente

Deep Blue-one
Beiträge: 862
Registriert: Dienstag 1. August 2017, 17:21

Re: Adsorption Elemente

Beitrag von Deep Blue-one »

Vielen Dank Dieter
Beste Grüße Gerhard
Benutzeravatar
tropicreef
Beiträge: 1166
Registriert: Mittwoch 3. Juni 2015, 15:26
Wohnort: 73054 Eislingen

Re: Adsorption Elemente

Beitrag von tropicreef »

Deep Blue-one hat geschrieben:Welchen Einfluss haben PH Wert KH;eventuell auch Temp
Eher anders herum. Phosphatadsorber senken - je nach eingesetzter Menge - recht schnell den pH Wert. Ebenso wird die Alkanität- zwar nicht so schnell- gesenkt. Nimmt man zuviel von den Adsorbern bspw. von Rowaphos, so wird sehr schnell der PO4 Wert gesenkt und zeitgleich die KH. Das möchten Korallen gar nicht.
Gruss Dieter
Deep Blue-one
Beiträge: 862
Registriert: Dienstag 1. August 2017, 17:21

Re: Adsorption Elemente

Beitrag von Deep Blue-one »

Dachte mir dass es da einen Zusammenhang gibt.
Beste Grüße Gerhard
Gweny
Beiträge: 3460
Registriert: Mittwoch 21. Oktober 2015, 21:27
Wohnort: Nürnberg

Re: Adsorption Elemente

Beitrag von Gweny »

Hallo Dieter,

bezüglich der Schwermetallbindung hab ich mal recherchiert. Im Forum hatte ich z.B. Molybdän gefunden. Allerdings hab ich auch mal Jörg kontaktiert und würde hiermit seine Antwort gerne posten:
Die Schwermetallbindung ist sehr unspezifisch, genau kann man das nicht festlegen. Wenn die organisch gebunden sind, können die auch über die organischen Anteile an die Oberfläche gebunden werden. Aber genauere Auskunft kann man dazu nicht geben. Das Hauptproblem ist aber, dass es immer zu Konkurrenzen kommen kann, z.B. werden Phosphat oder Silikat teils schwächer gebunden als z.B. Huminsäuren, d.h. es wird anteilig weniger Phosphat gebunden und die Oberfläche setzt sich mit den Gelbstoffen zu. Sowas kann auch immer mit Spurenstoffen passieren, .d.h, ob es überhaupt zu einer signifikanten Bindung kommt, ist nicht vorhersehbar.
Grüße miri
Benutzeravatar
tropicreef
Beiträge: 1166
Registriert: Mittwoch 3. Juni 2015, 15:26
Wohnort: 73054 Eislingen

Re: Adsorption Elemente

Beitrag von tropicreef »

dies wurde heute auf Facebook gepostet; schon beachtilich wie Phosphatadsorber im Vorfeld belastet sind
Stuart Bertram hat geschrieben:VIRGIN OR NON-VIRGIN
when it comes to PHOSPHATE REMOVERS???

The majority of iron based phosphate removers available are actually designed to be used for the commercial removal of Arsenic from mains water. Phosphate is not a generally problem in drinking water and is actually added in some areas to reduce the toxicity of old lead pipework.

In a water treatment plant, the media is used in large filtration beds to remove Arsenic, Phosphate and Heavy Metals. It is of ultimate importance to ensure that Arsenic levels in drinking water do not breach the maximum safe concentration, and so the media is changed before fully exhausted, whilst it still has some remaining capacity.

This non-virgin waste material often finds its way into the aquarium industry as low cost phosphate media and is easily identified by analysis using spectroscopy, which immediately shows extremely high levels of Arsenic, Phosphate and Heavy Metals bound to the media.

Under normal pH conditions these toxins will remain bound and not release, however they are taking up the points for adsorption on the surface and so any further phosphate removal is significantly reduced and short lived.

Interestingly 2/3 of the commonly sold brands that we tested appeared to be of non-virgin origin. (See the independant analysis of a couple of the typical products tested)

ROWAphos is the original Iron based phosphate remover used in the aquatic trade and is a virgin patented product guaranteed to remove more phosphate than any other product of its type on the market.

In our laboratory controlled tests on 12 different brands, Rowaphos removed 60% more phosphate than the best of those tested and almost 3 times more than 5 of the non virgin products.

In total 8 of the 12 products showed preloading which suggests that they are non virgin.

The impact on the phosphate removal capacity of the non virgin products is illustrated in the last image which tests the ability to remove phosphate in a single pass through the media, i.e. not recirculated.
Dateianhänge
Prüfbericht2.JPG
Prüfbericht1.JPG
Gruss Dieter
Antworten